Commercial Metal Roof Coating
Patched exposed-fastener panels get stripped, primed, re-fastened, and coated over every lap.
Commercial metal roof coatingCommercial Roofs · Stafford Springs, CT
Stafford Springs Metal Roof Coating Contractor
Extending Old Patched Metal Roofs With A Bonded Coating
As a Stafford Springs metal roof coating contractor, we strip failed patches, clean up mixed fasteners, and coat older commercial metal roofs so the new film bonds to clean steel.
Metal Roof Coating Over Old Patches in Stafford Springs
Stafford Springs metal roof coating jobs often start with roofs that have been patched for decades: roof cement over laps, tar around vents, and three kinds of screws in one row. A coating bonds poorly to those layers, so they come off or get tested first.
We run small adhesion pulls on test patches when an old layer looks firmly attached. Layers that fail the pull are scraped back to metal and primed.
- Old cement and tar removed from laps
- Adhesion test patches on layers that stay
- Mixed fasteners sorted and replaced
Patch Problems We Fix Before Metal Roof Coating in Stafford Springs
Older patched roofs show these conditions; each one changes the prep list.
- Repair First
Cracked Roof Cement
Brittle cement over laps holds water against the steel. It gets scraped off before primer.
- Repair First
Mixed Screw Types
Old nails, short screws, and long screws in one row loosen at different rates. We standardize them.
- Call Now
A Leak Through An Old Patch
Water at a spot already patched twice needs a real repair now. Call us.
- Watch
Rust Under Paint
Bubbled paint hides rust underneath; scraping shows how far it has spread.
- Watch
Tar Around Old Vents
Tar around curbs and vent pipes dries out and splits. It comes off and new flashing goes in.
Benefits of Coating Your Roof
A coating on an old roof replaces the patchwork with one consistent surface.
- Old mill buildings
- Shops on Main Street
- Garages
- Small warehouses
One Surface Instead Of Patches
Years of cement, tar, and caulk get replaced by one film across panels and laps.
Bond You Can Test
Adhesion pulls on test patches show the coating holds before the whole roof gets it.
Rust Stopped At The Source
Scraping under bubbled paint finds the rust, and primer stops it before coating.
A Clear Record
You get a list of what was removed, replaced, and coated, so the next repair starts informed.
Commercial Roof Coating Options for Stafford Springs
Older Stafford Springs buildings mix roof types, so we match each section to a system.
Silicone Roof Coating
Flat rear sections where patches hold puddles get silicone after the old layers come off.
Silicone roof coating
Acrylic Roof Coating
Sloped panels with peeling paint take acrylic once rust is primed and edges are sealed.
Acrylic roof coating
Spray Foam Roofing
Low-slope sections with many old vent patches can take foam that wraps each penetration.
Spray foam roofing
Shingle Roof Coating
Shingle sections on older blocks get a shingle coating after damaged tabs are replaced.
Shingle roof coatingLeaking Through A Patch That Already Failed Once?
Leaking Now
Call and tell us where the old patch is and when it leaks; we look at that lap first.
Call UsPlanning Ahead
Planning to replace the patchwork with a coating? Get a ballpark range by roof size.
Get A Free Ballpark EstimateMetal Roof Coating Steps for Older Stafford Springs Roofs
Five steps, with the patch removal built into the plan.
Inspect Your Roof
We map every old patch, sample the paint and cement layers, and note which fastener types sit in each row, so the prep list matches the roof's real history.
Test The Old Layers
Small test patches get coated and pulled after they cure, which tells us which old layers can stay under the new coating and which have to come off.
Strip And Prime
Failed cement, brittle tar, and loose paint are scraped back to metal, then rust-inhibiting primer goes on every bare spot and stained lap.
Reset Fasteners And Flashing
Mixed screws are pulled and replaced with one consistent fastener, and vents and curbs get new flashing in place of the old tar collars.
Coat The Whole Roof
Field coats cover panels and laps at full thickness, checked with a wet-mil gauge, so the patchwork ends up under one continuous surface.
Nearby Towns Served From Stafford Springs
Older shops, mills, and garages in these towns are a big part of our coating work. Elsewhere? Call us or send us a message.
Thompsonville
Storefront blocks; shared-wall flashing and alley staging.
Thompsonville metal roof coatingSuffield
Farm and storage roofs; washers and laps.
Suffield metal roof coatingWindsor Locks
Warehouses and docks; staging out of truck lanes.
Windsor Locks metal roof coatingEast Granby
Rooftop units and solar racks; curbs first.
East Granby metal roof coatingHazardville
Strip plazas; one storefront at a time.
Hazardville metal roof coatingGranby
Weather windows; repairs early, coating in dry stretches.
Granby metal roof coatingSomers
Churches and schools; dates set around events.
Somers metal roof coatingEllington
Light industrial; storm repairs before coating.
Ellington metal roof coatingBroad Brook
Several buildings; phased plan, worst roof first.
Broad Brook metal roof coatingEast Windsor
Large warehouses; coated in sections.
East Windsor metal roof coatingUnion
Rural metal buildings; fully supplied trip.
Union metal roof coatingStafford
Roofs with repair history; written record.
Stafford metal roof coatingWillington
Eaves, gutters, and edge trim first.
Willington metal roof coatingChaplin
Coat-now versus replace-first areas.
Chaplin metal roof coatingStafford Springs Metal Roof Coating Questions
Answers for owners of older, patched commercial roofs.
Old Roofs
Is metal roof coating available for older commercial buildings in Stafford Springs?
Yes, including roofs patched many times over. Old cement, tar, and caulk get removed or tested, mixed fasteners are replaced, and panels too far gone are swapped. Then the coating goes on clean, primed steel.
Can you coat over old roof cement?
Only if it passes an adhesion test. Most aged cement is brittle and comes off, because a coating that bonds to a failing layer peels with it.
Cost
What does Stafford Springs metal roof coating cost?
As a ballpark, about $2.50 to $4 per square foot of roof area. Patch removal and fastener replacement on older roofs push the price toward the top of that range; the inspection sets the real number.
Does removing old patches add much?
It adds labor in proportion to how much patching there is. We measure the patched area during the inspection and show it as its own line in the price.
Contractor
Is there a metal roof coating contractor near Stafford Springs?
Yes. We cover Stafford Springs and the rest of Stafford from Enfield. Call us or request a ballpark estimate to set up a roof walk.
Who handles permits in Stafford Springs?
Stafford Springs is part of the Town of Stafford, so the Stafford building department handles permit questions for commercial roof work there.
Hire a Stafford Springs Metal Roof Coating Contractor
Send a few photos of the old patches if you have them, and we will plan the inspection of your Stafford Springs roof.